Regulated Power Supply
Bench DC/AC power supply with optional current limit. DC mode for fixed rails (5V, 12V, etc.); AC mode for sine sources. Visually shares the signal-generator chassis so no new Web Component is needed. The current limit is enforced by the circuit verifier — if any load pulls more than the configured amperage, Run is blocked with a ‘source-overload’ warning, mimicking a real bench supply’s foldback behavior.
| Pin | Signals |
|---|---|
| SIG | — |
| GND | — |
Attributes
Section titled “Attributes”Editable from the part inspector:
| Attribute | Default | Description |
|---|---|---|
mode |
dc |
DC for fixed rails, AC for sine waveform output |
voltage |
5 |
Output voltage in V (DC mode) or peak amplitude (AC mode) |
frequency |
50 |
Frequency in Hz (AC mode only) |
currentLimit |
1 |
Maximum sourced current in A. The verifier warns when exceeded. |
Use it
Section titled “Use it”Add it from the component picker — search for “Regulated Power Supply” (tags: power-supply, regulated, source, psu, bench). Right-click it on the canvas for the in-editor datasheet, and check the examples gallery for circuits that use it.